Decking Stain and Protector - Light Grey - Wilko

This product is suitable for use on wooden patios, stairs, and bathroom floors. It can be used on both treated and untreated wood.

The stain is touch-dry in approximately two hours after application.

No, the Decking Stain and Protector provides a slip-resistant finish, enhancing safety.

The surface must be clean, dry, and free from loose debris. Ensure any old coatings are removed or properly prepared. Test on a small area first.

It's recommended to remove or thoroughly prepare existing coatings. Test on an inconspicuous area to ensure compatibility. For best results, apply to bare or properly prepped wood.

Clean the surface with water and a mild detergent. Avoid using abrasive cleaners.

Typically, one or two coats are sufficient, depending on the desired finish and the condition of the wood. Apply thin, even coats and allow adequate drying time between them.

Ensure the product was applied evenly and that the surface was uniformly prepared. Multiple thin coats may be more effective than one thick coat. Allow adequate drying time between coats.

This can occur if applied too thickly or in very humid conditions. Ensure good ventilation. A light sanding with fine-grit sandpaper may help resolve tackiness, followed by a light wipe down.

This is an indication that the product is working effectively and providing water protection. This is the desired outcome.

This may indicate inadequate surface preparation or application on a damp surface. Ensure the wood was completely dry and clean before application. For future applications, ensure thorough preparation and adherence to drying times.