Window Film - Frosted Stripes Design

The film is designed for single application. While it might be possible to carefully remove and reapply it, the adhesive properties may be compromised, leading to less effective adhesion and potential damage.

The frosted stripe design offers high privacy by obscuring clear views. However, it does not create a complete blackout effect; some light will still pass through, and shapes may be discernible in very bright conditions.

Yes, the film is waterproof and designed for use in humid environments like bathrooms, making it suitable for shower doors.

To remove, gently heat the film with a hairdryer on a low setting to soften the adhesive, then peel it away slowly from a corner. Any remaining residue can be cleaned with warm, soapy water.

Please refer to the product packaging or listing for specific dimensions, as sizes can vary by roll.

It is designed for glass surfaces. Application on mirrors might work, but results can vary, and it's best suited for standard window glass.

Gently lift the affected corner of the film and reapply, using a squeegee to press out air bubbles towards the edges. For stubborn bubbles, a pinprick may release trapped air, but use with caution.

Ensure the glass surface is thoroughly cleaned and slightly damp before application. Check that the protective backing has been fully removed. If the film is old, its adhesive may have degraded.

Use a sharp, new craft knife or a precision cutting tool. A metal ruler can be used as a guide for straight cuts.

Soak the residue with warm, soapy water and gently scrape it away with a plastic scraper or a cloth. For stubborn residue, a commercial adhesive remover can be used sparingly.