John Guest MDPE Compression Stop End - 32mm - Blue

This John Guest fitting is specifically designed for 32mm outside diameter Medium Density Polyethylene (MDPE) pipe used in cold water systems.

No, this fitting is strictly for cold water applications and is not rated for hot water systems.

No special tools are required beyond two standard wrenches to tighten the compression nut. No heat or glue is needed.

WRAS approval signifies that the product has been rigorously tested and meets the stringent standards set by the Water Regulations Advisory Scheme for use in public water supplies, ensuring it is safe for drinking water.

Each pack contains ten (10) John Guest MDPE Compression Stop Ends.

While it is possible to disassemble compression fittings, it is generally recommended to use new fittings for re-installations to ensure a reliable, leak-free seal. The integrity of the sealing components can be compromised upon disassembly.

A single stop end measures approximately 76mm in height, 63mm in length, and 63mm in width.

Ensure the MDPE pipe was fully inserted and seated. Re-tighten the compression nut following the installation instructions. Check the pipe end for damage or deformation that might prevent a good seal. Ensure the correct size pipe (32mm MDPE) is being used.

Verify that the pipe is clean, square-cut, and free from burrs. Ensure you are using the correct 32mm MDPE pipe. Slightly warming the pipe end with warm water (not hot) can sometimes make insertion easier, but avoid this if working with already buried pipes.

Do not install a damaged fitting. Contact the supplier for a replacement. Inspect the fitting upon receipt and before installation.