Roland Multi-Format Video Switcher - V-40HD

Yes, the V-40HD is designed for multi-format input. You can connect HDMI, RGB/Component, and Composite sources on each of the four input channels at the same time.

The V-40HD supports input and output resolutions up to Full HD (1080p) and WUXGA (1920x1200).

When HDCP mode is enabled, the V-40HD can process and switch protected content from sources like Blu-ray players or game consoles. However, this mode only allows output via HDMI to an HDCP-compliant display.

Yes, the V-40HD features analog audio inputs that can be mixed with video and embedded into the HDMI output signal, which is useful for streaming and recording.

Multi-Zoom allows you to digitally zoom into an input source, creating the effect of multiple camera angles from a single source. This can be chained to up to three additional virtual inputs.

No, the V-40HD utilizes an efficient heat-radiating design that eliminates the need for a cooling fan, ensuring quiet operation.

The V-40HD has five internal memory banks, each capable of storing five sets of settings, allowing you to save a total of 25 configurations. These can also be backed up to a USB flash drive.

Verify all source and output connections are secure. Ensure the correct input and output selectors are engaged. Check that the output resolution is supported by your display. If using HDCP content, ensure HDMI output and an HDCP-compliant display are used.

Utilize the audio delay settings on the V-40HD to match the audio input timing with the video signal. Ensure embedded audio from HDMI sources is correctly passed through.

Confirm that the output is set to HDMI and that the connected display or projector explicitly supports HDCP. Composite and RGB/Component outputs are not compatible with HDCP content.

Check the input resolution settings and ensure they are within the V-40HD's supported range. Verify the individual input scaler settings are configured appropriately.

Try cycling the power off and on. If the issue persists, connect a USB drive to the USB port and attempt to save the internal memory settings, then perform a factory reset if available (refer to the manual).