Giro Fixture MIPS II MTB Helmet - Black

MIPS® (Multi-directional Impact Protection System) is a leading slip-plane inside the helmet designed to reduce rotational forces on the brain during angled impacts. This can help provide a higher level of protection than helmets without MIPS®.

The Roc Loc® Sport fit system uses a dial on the back of the helmet. Loosen the dial by turning it counter-clockwise, place the helmet on your head, then tighten by turning the dial clockwise until a snug, secure fit is achieved.

Yes, the design of the Roc Loc® Sport system and the helmet's rear structure accommodates ponytails comfortably.

The Giro Fixture MIPS II Helmet uses Universal Fit™ sizing (UA: 54-61cm). It's recommended to measure your head circumference and compare it to the stated range for the best fit.

Clean the helmet's exterior and interior with mild soap and cool water using a soft cloth. The internal padding can be removed and hand-washed, then air-dried thoroughly.

Giro typically offers a limited warranty against defects in materials and workmanship. Please refer to the product documentation or Giro's official website for specific warranty details.

While designed for MTB, the MIPS® protection makes it suitable for general cycling where impact protection is desired. However, it is not certified for sports like skiing or skateboarding.

Ensure the Roc Loc® Sport dial is tightened appropriately. Check that the rear retention cradle is positioned correctly on your head. Readjust the side straps to form a 'Y' below your ears.

Loosen the Roc Loc® Sport system slightly. Ensure the helmet is sitting level on your head, not tilted too far forward or back. The padding may need time to conform to your head shape, or consider checking fit with different head orientations.

Adjust the strap dividers so they sit just below your earlobes. Ensure the straps are snug but not overly tight. The internal padding can help mitigate chafing; ensure it is properly seated.

This is normal due to sweat. Remove the padding and allow it to air dry completely after each use. Ensure the helmet is stored in a well-ventilated area.