Tatti Lashes 1-Step Press™ Lash Applicator

No, this applicator is specifically designed for the Tatti Lashes 1-Step Press™ pre-glued lash system. It is not optimized for magnetic lashes or traditional glue-on lashes.

It is recommended to clean the applicator after each use to maintain hygiene and the effectiveness of the non-stick coating. Gently wipe with a makeup remover or alcohol-based solution and allow to dry.

The applicator has a total length of 8.5cm, and the tip is approximately 1cm wide.

Yes, the non-stick coating also aids in gentle removal. Use the tip or base to carefully lift and remove the pre-glued lashes.

With proper care and cleaning, the non-stick ceramic coating is designed to be durable. Avoid abrasive cleaning materials which could damage the coating over time.

No, it is made from stainless steel with a ceramic coating, making it lightweight and comfortable to hold for precise application.

Ensure the applicator is clean and completely dry before use. Double-check that you are using the correct Tatti Lashes 1-Step Press™ lashes, as the non-stick coating is optimized for them. A very light mist of setting spray on the lashes *before* application may help, but test on a single lash first.

Practice makes perfect. Ensure you have good lighting and a steady hand. Use the fine tip to gently nudge lashes into the desired position. If applying to the inner corner, tilt your head slightly back and look downwards into a mirror.

Ensure you are using the flat base of the applicator to gently clamp and fuse the pre-glued lash to your natural lash line. Apply gentle pressure for a few seconds. Make sure your natural lash line is clean and free from oils or old adhesive.

This is a normal characteristic of the non-stick coating. Ensure you have a firm grip on the applicator handle. If your hands are very dry, a very small amount of grip-enhancing product on your fingertips might help, but avoid transferring it to the applicator head.