HydroSure Wall Plate Compression Elbow - 32mm x 1" - Blue - Pack of 3

While designed for underground installation, it can be used above ground if protected from UV light and physical damage. Its primary design focus is subterranean robustness.

WRAS (Water Regulations Advisory Scheme) approval signifies that the product meets the high standards for water quality, safety, and performance required in the UK for products used in contact with drinking water.

No, this fitting is specifically designed for 32mm external diameter MDPE (Medium-Density Polyethylene) or HDPE (High-Density Polyethylene) pipes. Using it with other pipe materials may result in leaks or failure.

The fitting is designed to safely handle working pressures up to 16 bar.

The O-ring is designed to contract tightly around the pipe wall when water pressure is applied, creating a secure seal that actively prevents leaks even under high pressure.

You will need a pipe cutter to ensure a clean, square cut on the pipe end, and standard wrenches for tightening the compression nut.

The wall plate provides a stable mounting surface, commonly used when passing through a wall or structure, offering support and a clean termination point for the pipe.

Ensure the pipe is fully inserted, the O-ring is correctly seated, and the compression nut is tightened appropriately. Check pipe for any nicks or damage that could compromise the seal. Ensure pipe is square cut.

Verify that you are using the correct 32mm pipe size and that the pipe end is clean and free from burrs or deformation.

Confirm the pipe material is compatible (MDPE/HDPE). Re-seat the O-ring and ensure the compression nut is tightened securely, but avoid over-tightening which can damage the pipe or fitting.