Hansgrohe Crometta 100 Shower Handset - 2 Sprays - 9 l/min

EcoSmart technology is integrated into Hansgrohe products to limit water flow rate, thereby reducing water and energy consumption by up to 60% compared to conventional products, without sacrificing showering comfort.

You can switch between the 'Rain' and 'IntenseRain' spray modes by simply turning the spray disc on the front of the showerhead.

Yes, the Hansgrohe Crometta 100 EcoSmart hand shower is suitable for instantaneous water heaters (continuous flow).

It is recommended to rub the silicone nozzles regularly, ideally after each use or at least weekly, to prevent limescale buildup and maintain optimal spray performance.

The flow rate is limited to a maximum of 9 liters per minute at 3 bar water pressure.

The showerhead has a diameter of 100 mm.

Yes, this hand shower features a standard G ½ connection thread and is compatible with most standard shower hoses.

Check and clean the rinseable dirt filter located inside the shower hose connection. Ensure the QuickClean silicone nozzles are free of limescale by rubbing them. Verify that the water supply is fully open and that no other fixtures are drawing significant amounts of water simultaneously.

Ensure the shower hose is securely connected to the hand shower. Check the rubber seal or washer inside the connection and replace if damaged. Hand-tighten the connection firmly; if still leaking, use a wrench to tighten slightly, but avoid overtightening.

Gently rub the silicone nozzles on the spray disc to dislodge any limescale buildup. If the issue persists, unscrew the spray disc (if possible, depending on model variation) or the entire showerhead for a more thorough cleaning.

This issue is typically related to the water heater or mixing valve, not the hand shower itself. Ensure your water heater is functioning correctly and the mixing valve is set appropriately. The EcoSmart flow rate might require your water heater to operate at a slightly higher setting.