Forgefix Spectre Collated Framing Nails - Silver - SPEFNR2850B

These nails are compatible with 34° collated D-head framing nailers, both pneumatic and cordless.

The bright finish offers basic protection but is not intended for prolonged exposure to weather or moisture. For exterior applications, consider galvanized or stainless steel nails.

Service Class 1 indicates that the timber is protected from the weather and is only subject to occasional moisture. These nails are suitable for such conditions.

No, these are framing nails designed for structural applications. For finer work, you would typically use smaller brad nails or pins.

Each box contains 3,300 nails.

These nails have a smooth shank, designed for high-speed driving.

The D-head is larger than a round head and will be visible unless countersunk and filled. It's designed for structural integrity where finish appearance is secondary.

Check air pressure (for pneumatic nailers) or battery charge (for cordless nailers). Ensure the depth adjustment on your nail gun is set correctly. Verify that the nails are loaded properly and are not bent.

Ensure you are using the correct type and size of nail for your tool. Clean the nail gun's magazine and driver blade. Check for any obstructions or damage to the tool's mechanism.

Ensure the nail tip is sharp and the nail is driven perpendicular to the wood grain. If splitting persists, consider a slightly smaller gauge nail or pre-drilling pilot holes in very hard woods, although this negates some of the speed advantage.

Adjust the depth setting on your nail gun to drive the nail head slightly below the wood surface. Ensure the air pressure is adequate for the nailer to overcome the wood's resistance.