National Ventilation Extractor Fan Condensation Trap - 100-110mm

This trap is designed to fit both 100mm I.D. and 110mm diameter pipes.

Install the trap in the vertical duct run, ideally as low as possible while maintaining a downward slope for the overflow pipe.

The overflow pipe is used to drain the collected condensation to a safe location outside, preventing water damage.

If necessary, clean the trap with a damp cloth. Avoid using harsh chemicals.

It is recommended to inspect the trap regularly, particularly during periods of high humidity or heavy use of the ventilation system.

If the overflow pipe gets blocked, remove the blockage to allow proper drainage. Check for debris and obstructions regularly.

Yes, as long as the ducting from the extractor fan is compatible with the trap's size (100mm or 110mm).

Check the condensation trap and overflow pipe for blockages. Ensure the trap is correctly installed with a proper slope for drainage. If the problem persists, inspect the ducting for damage.

Check for blockages in the overflow pipe. Verify the trap is installed with a proper slope. Ensure the system is generating condensation (e.g., extractor fan is running).