PGB C-Tec Power Grab n Bond Construction Adhesive - 290ml

PGB C-Tec Power Grab n Bond can bond stone, granite, marble, concrete, wood, MDF, fiberglass, all metals, glass, mirrors, and most plastics (excluding PP, PE, and PTFE).

Yes, it is suitable for both interior and exterior use due to its solvent-free formula.

The full cure time is faster than typical epoxies, but it depends on environmental conditions. Always refer to the product specifications for exact cure times.

No, Power Grab n Bond does not require mixing, unlike two-component epoxy adhesives.

The shelf life is typically 12 months from the date of manufacture when stored in a cool, dry place. Check the product packaging for specific details.

The initial strength for horizontal bonding (uncured) is 100g / cm² and 20g / cm² for vertical bonding (uncured).

Store in a cool, dry place, away from direct sunlight. Ensure the container is sealed properly.

Yes, but it is not suitable for bonding PP, PE, and PTFE plastics. Always test on a small area first.

Ensure surfaces are clean and properly prepared. If the surface is non-porous, lightly abrade it before applying the adhesive. Check the expiration date of the adhesive.

Ensure that the ambient temperature is within the recommended range. Low temperatures can slow down the curing process. Verify that the adhesive has not expired.

Make sure that the surfaces were properly prepared and cleaned. Check that the correct amount of adhesive was applied and that the surfaces were in contact during the curing time. Allow for the full cure time before stressing the bond.