Slumberdown Sleepy Nights Electric Blanket - White

First, ensure the blanket is unplugged from the mains. Then, detach the controller from the blanket. You can machine wash the blanket according to the care label, typically on a gentle cycle at a low temperature. Always air dry completely before reconnecting the controller and plugging it in.

BEAB (British Electrotechnical Approvals Board) Approval is a European safety mark that indicates a product has been independently tested and found to comply with stringent safety standards. It provides assurance of the product's quality and safety.

While the blanket is BEAB approved for safety, it is generally recommended to use it to pre-warm your bed and turn it off or set it to the lowest setting (if applicable and comfortable) once you are in bed. Always consult your specific user manual for recommendations on overnight use.

Yes, the Slumberdown Sleepy Nights Electric Blanket is BEAB approved, signifying it has met high safety and quality standards. Always follow the setup, care, and usage instructions provided in the guide and user manual for safe operation.

The Slumberdown Sleepy Nights Electric Blanket is available in Single (61cm x 122cm), Double (107cm x 122cm), King (142cm x 150cm), and Super King (172cm x 150cm) sizes.

No, this product is specifically designed as an 'underblanket.' It should be placed flat on your mattress, beneath a fitted sheet or mattress protector, and is not intended for use as a throw or overblanket.

Ensure the power cord is securely plugged into a working outlet and the detachable controller is firmly connected to the blanket. Check if the controller is switched 'on' and a heat setting is selected.

Unplug the blanket from the wall socket, wait a few minutes, then plug it back in. Ensure all connections are secure. If the issue persists, refer to the user manual or contact customer support.

Adjust the heat setting using the controller. Allow 10-15 minutes for the blanket to reach the new temperature. Remember that thicker bedding layers above the blanket can trap more heat.

Immediately unplug the blanket and disconnect the controller. Do not use the blanket until it is completely dry. If the blanket was soaked, it might be safer to replace it, especially if the internal wiring could be compromised.

Ensure the blanket is laid flat on the mattress and covered by a fitted sheet to prevent creasing. Using a creased blanket can cause hotspots or damage the internal elements. Always ensure it's flat before turning it on.