Under Control Instruments Immersion Heater - 6kW - 230V - 460mm Immersion Depth

This unit is designed primarily for liquid heating applications; please verify the fluid compatibility with Incoloy 800 before installation.

The thermostat is a standard industrial control component designed for process regulation within a 30–85°C range.

Yes, it is designed for a 230V single-phase supply which requires phase, neutral, and earth connections.

Operating the heater without full immersion will cause overheating, likely leading to the failure of the heating element.

It is recommended to use an appropriately rated junction box and cable if an extension is necessary, handled by a qualified electrician.

IP45 indicates protection against solid objects over 1mm and low-pressure water jets from any angle.

Check the power supply and ensure the thermostat is set to a temperature higher than the current liquid temperature.

Verify the element has not been dry-fired; check continuity across the element terminals with a multimeter after disconnecting power.

Ensure the thermostat probe is correctly positioned and not obstructed; verify the supply voltage is consistently at 230V.