JG Speedfit Bent Tap Connector - 10mm X 1/2"

No tools are required for the initial push-fit connection. You may need a pipe cutter to prepare the pipe.

Yes, the fitting can be demounted and reused, but inspect the fitting and pipe end for damage before reassembly.

The fitting is compatible with Speedfit PEX and polybutylene plastic pipe (inserts required) and copper pipe.

The fitting is designed for standard domestic water pressure. Always consult the product specifications for exact pressure ratings.

Yes, the JG Speedfit Bent Tap Connector is suitable for use in both hot and cold water and central heating systems.

No sealant is required for the push-fit connection. The fitting uses an internal O-ring to create a watertight seal.

Ensure the pipe end is cut cleanly and squarely. Push the pipe fully into the fitting. Engage the Twist & Lock mechanism.

The JG Speedfit Bent Tap Connector is designed, manufactured, and assembled in the UK.

Ensure the pipe is fully inserted and the connection is secure. Check the O-ring for damage. Verify the Twist & Lock mechanism is properly engaged. If using plastic pipe, confirm that inserts have been installed.

Ensure the pipe end is clean and free of burrs. Make sure the pipe is pushed fully into the fitting. If using plastic pipe, ensure that inserts have been installed.

Make sure you are pushing the collet towards the fitting body before pulling the pipe.