Everbuild One Strike Filler - White - 450ml

Yes, Everbuild One Strike Ready Mixed Filler is suitable for both indoor and outdoor use, provided the surface is dry and clean during application.

It can fill holes up to 75mm deep in a single application without needing to build up layers, thanks to its non-slumping formula.

The filler is typically ready to paint or wallpaper over in just 30 minutes. Drying time can vary slightly based on temperature, humidity, and fill depth.

The filler leaves a smooth finish that often requires little or no sanding. However, for a perfectly flush surface, a light sand may be performed if desired, followed by dusting.

Yes, it can be used on wood surfaces, as well as walls, ceilings, brickwork, render, coving, and stone.

Yes, it is a ready-mixed formula, so you can use it straight from the tub without any additional preparation or mixing.

It dries to a brilliant white color, providing an excellent base for painting or wallpapering.

Ensure ambient temperature is adequate and humidity is not too high. Very deep fills, while designed for one-go, might take slightly longer in ideal conditions. Also, check surface for moisture, as dampness can prolong drying time.

This can happen if the filler was not sufficiently smoothed during application or if too much was applied. Apply slightly less next time and smooth more carefully immediately after application, aiming for a flush finish.

This typically indicates insufficient surface preparation. The substrate must be clean, dry, and free of dust, grease, or loose particles for optimal adhesion. Ensure old loose paint or plaster is removed.

Ensure the filler is completely dry and cured before applying paint or wallpaper. A light sanding might be needed if the surface texture is not to your preference, followed by thorough dusting to remove any residue.