Araldite Rapid Adhesive - 2 x 15ml Tubes

Araldite Rapid typically sets within 5 minutes, but full strength is achieved within a few hours. The setting time can vary depending on the temperature and humidity.

Araldite Rapid bonds to most plastics, but it is recommended to test on a small, inconspicuous area first, as adhesion can vary depending on the type of plastic.

Yes, Araldite Rapid is water-resistant, making it suitable for use in environments where moisture is present.

Store the tubes in a cool, dry place and ensure the caps are tightly sealed after use.

Yes, Araldite Rapid can be painted after it has fully cured.

Clean up any excess adhesive with a solvent like acetone before it cures. Once cured, it is very difficult to remove.

Araldite Rapid bonds to metal, wood, masonry, ceramics, glass, dry concrete, chipboard, leather, cardboard, fabric, rubber, and most plastics.

The shelf life of Araldite Rapid is typically 24 months from the date of manufacture when stored properly.

Ensure the two components were mixed thoroughly in the correct ratio. Check the expiration date. Make sure the surfaces were clean and dry.

Make sure surfaces were properly prepared and roughened, if necessary. Ensure sufficient adhesive was applied. Allow adequate curing time before stressing the bond.

Ensure the product is stored at a suitable temperature. If the product is too thick, try to warm the product slightly before mixing.