Rust-Oleum Universal Spray Paint 400ml - Titanium Silver

A 400ml can covers approximately 2m² depending on the surface and application technique.

Yes, Rust-Oleum Universal Metallic Spray Paint can be used on plastic. Ensure the plastic surface is clean and properly prepared.

The paint typically dries to the touch in a few minutes, but it is recommended to allow at least 24 hours for complete drying and curing.

While the paint is a paint and primer in one, priming is recommended for bare metal surfaces to enhance adhesion and rust prevention.

Yes, this paint is suitable for both interior and exterior use. It is fade and chip resistant.

After use, turn the can upside down and spray until only propellant comes out to clear the nozzle. If the nozzle clogs, clean it with a pin.

Clean the surface, sand it lightly, and prime if necessary. Ensure the surface is clean, dry, and free of any contaminants.

Apply thinner coats and ensure the can is held at the correct distance from the surface. Reduce the amount of paint applied in each pass.

Ensure the surface is properly prepared by cleaning, sanding, and priming if necessary. Allow for complete drying and curing time.

Shake the can thoroughly before and during application. Apply multiple thin coats, ensuring even coverage and adequate drying time between coats.

Check the nozzle for clogs and clean it with a pin if needed. Ensure the can is shaken well and the trigger is fully pressed.