Wavin Osma RoundLine Gutter Union - 112mm - White

The Wavin Osma RoundLine Gutter Union is designed for the 112mm gutter system with a circular 68mm...

Best current price£5.50from Travis Perkins

One Offer

1 offer from £5.50

View price history by clicking the chart icon.

Travis PerkinsWavin Osma RoundLine gutter union 112mm grey 0T009G
£30.00 delivery
£5.50
Visit shop

Product Information

Full details

The Wavin Osma RoundLine Gutter Union (0T009w) is an essential component for homeowners and contractors maintaining or installing a 112mm gutter system with a 68mm circular downpipe. It provides a robust, watertight connection between two sections of guttering, ensuring efficient rainwater management for domestic properties. While highly reliable due to its industrial-standard design, users should ensure precise measurement and alignment during installation to fully leverage the integrated thermal expansion features.

All features

Model Part Number0T009w
BrandOsma

Extended Product Information

FAQs

Is this union compatible with square guttering?

No, this component is designed exclusively for the 112mm RoundLine (circular) gutter system.

Does this union come with seals?

Yes, it features wide, factory-retained seals integrated directly into the housing.

Why are there markings inside the union?

The markings indicate the correct gap required to allow for thermal expansion of the guttering in hot or cold weather.

Can I use this on a 115mm system?

No, this is specifically calibrated for the 112mm Osma RoundLine system and may not provide a secure fit on other sizes.

How do I ensure a watertight seal?

Ensure the gutter is cut cleanly, pushed into the union past the seal, and aligned correctly with the thermal expansion markers.

What standards does this product meet?

This product conforms to BS EN 607:2004, the standard for plastic rainwater piping systems.

Troubleshooting

Joint is leaking after installation

Check if the gutter end was cut square and that it is fully seated against the internal stops of the union.

Difficulty snapping the gutter into the union

Ensure the rubber seal is correctly seated and apply a small amount of silicone lubricant if necessary to help the gutter slide into position.

Joint movement or rattling

Verify that the gutter brackets are properly spaced on either side of the union to support the weight of the gutter.

Pros and Cons

Pros

  • Meets BS EN 607:2004 quality standards
  • Integrated seals ensure a leak-free joint
  • Helpful expansion guides prevent damage from thermal movement
  • Lightweight yet durable construction

Cons

  • Compatible only with 112mm RoundLine systems
  • Requires precise cutting of gutters for optimal seating
  • Not intended for heavy-duty industrial or commercial high-capacity systems

Setup, Compatibility & Care

To install, ensure the gutter ends are cut square and are free of burrs or jagged plastic. Clean the surfaces to ensure no debris prevents the seal from seating properly. Align the gutter sections with the union, ensuring the ends match the designated thermal expansion lines marked on the inner profile. For maintenance, periodically clear the guttering of leaves and debris to prevent blockages that could cause water to pool and put unnecessary weight on the joints. The union is compatible exclusively with the Osma 112mm RoundLine system and is not interchangeable with other profiles or brands.

Similar items

Price History

DatePrice
Visit shop