Simpson Strong-Tie Truss Clip - Silver - TCP47

The TCP47 Truss Clip is primarily used to provide wind restraint by securely attaching girders, trusses, and rafters to wall plates.

This clip is specifically designed to fit joists that are 47mm wide.

The speed prong allows for quick, temporary attachment of the clip, making it easier to position framing members during installation before permanent fastening.

The obround (slotted) holes are designed to make driving nails easier and more forgiving, allowing for slight adjustments and reducing the risk of splitting the wood.

Yes, in addition to wind restraint, it may be used for general purposes, strong-back attachments, and other situations where one member crosses another, provided the dimensions are compatible.

Typically, construction nails such as 10d or 16d galvanized nails are recommended. Always consult local building codes for specific fastener requirements.

The clip is galvanized for corrosion resistance, making it suitable for most standard construction environments. However, prolonged exposure to harsh corrosive elements without protection may lead to degradation over time.

Verify that the joist is exactly 47mm wide. Ensure there is no debris or damage to the lumber that is preventing a flush fit.

Ensure you are using the correct size and type of nails. The obround holes are designed for easier driving, but ensure nails are not bent and are entering the lumber at the intended angle.

Apply steady, direct pressure when using the speed prong. If the prong bends significantly, it may indicate excessive force or a suboptimal angle of approach; reposition and try again.

The clip is galvanized for protection. Light surface rust may occur but typically does not compromise structural integrity. If extensive corrosion is present, the clip may need replacement, especially in critical structural connections.