Stanley Aviation Snips - Left Cut - 250mm

These snips can cut up to 18 gauge steel, as well as aluminum, sheet UPVC, wire mesh, leather, copper, and plastic.

The length of these snips is 250mm (10 inches).

The serrated cutting edge helps prevent slippage when cutting, ensuring a clean and precise cut.

Yes, these snips are designed for cutting curves. The left cut design is specifically for cutting to the left.

Clean the blades after each use to remove debris. Wipe the handles to remove any dirt or oil.

Warranty information is not available in the product data, please refer to the manufacturer's warranty information.

The bi-material handles provide extra comfort and grip, reducing hand fatigue during extended use.

Store the snips in a dry place to prevent rust. Apply a light coat of oil to the cutting edges periodically.

Check if the material is within the snip's capacity (up to 18 gauge steel). Ensure the blades are clean and free of debris. Make sure you are cutting with the correct cutting edge.

Make sure you are not trying to cut material that is too thick. Check for any obstructions in the hinge mechanism and clean if necessary. If the issue persists, the snips might need lubrication at the hinge.

Inspect the latch mechanism for any damage or obstructions. Clean the latch and surrounding area. If the issue persists, the latch may need adjustment or replacement.