Godox Standard Reflector - AD300 Pro

The main benefit is to enhance and refine the light output from your Godox AD300 Pro or AD400 Pro, providing smoother, more even illumination with maximum efficiency.

This reflector is specifically designed for the Godox AD300 Pro and AD400 Pro. Compatibility with other models is not guaranteed due to differing mount systems.

The gel filters are typically designed to be inserted into a holder or slot on the reflector or a compatible modifier. Consult the specific instructions that came with your gel filter kit, as attachment methods can vary.

No, the stipple surface is designed to diffuse and smooth light without altering the flash's color temperature. The included gel filters are what allow for color changes.

The 50-degree grid narrows the beam angle of the light, reduces light spill, and allows for more precise control over where the light falls, creating a more focused or dramatic effect.

The reflector is designed to be lightweight and portable, adding minimal bulk to your existing monolight setup.

Gently wipe the interior aluminum surface with a soft, dry microfiber cloth. Avoid using any liquids, solvents, or abrasive materials that could damage the delicate stipple finish.

Ensure you are using a compatible Godox monolight (AD300 Pro or AD400 Pro). Realign the mount and twist firmly until it clicks and locks into place. Check the mount points on both the reflector and the flash for any debris.

Verify that the reflector is properly seated and locked onto the flash head. Ensure the flash tube inside the monolight is clean and centered. If using additional modifiers like grids, ensure they are correctly attached.

Check that the monolight's power setting is appropriately adjusted. Ensure the reflector is clean. The stipple finish is designed to soften light, which can slightly reduce the perceived intensity compared to a bare flash, but the overall output should be efficient.