Gainsborough Set Of 12 Solar Stake Lights - White

After a full day's charge in direct sunlight, the lights typically operate for 6-8 hours. Actual duration can vary based on sunlight intensity and weather conditions.

No, these solar lights are designed with an automatic sensor that turns them on when ambient light levels drop and off when they detect sufficient light, typically at dawn.

Yes, they are built to be rust and weather-resistant, making them suitable for year-round outdoor use. However, extreme conditions like heavy snowfall or prolonged ice may impact performance or longevity.

Use a soft, damp cloth to gently wipe the solar panel. Avoid using harsh chemicals or abrasive materials that could scratch or damage the surface.

The total height of each light, including the stake, is approximately 34.5cm.

The product description does not specify if the batteries are user-replaceable. For most solar stake lights, the integrated rechargeable battery is designed to last for several seasons.

They will still function, but their performance will be affected. Indirect or partial sunlight will result in shorter illumination times and potentially dimmer light. For best results, place them in areas with maximum direct sun exposure.

Ensure the solar panel is clean and receiving direct sunlight for charging. Check that the on/off switch (if present on the unit) is in the 'on' position. Try repositioning the light to an area with more direct sun exposure.

The battery may not be fully charging. Ensure the solar panel is clean and has had sufficient sunlight. Cloudy weather or reduced daylight hours can impact performance. Allow multiple days of good sunlight to fully charge the battery.

This could indicate a weak battery charge or a dirty solar panel. Clean the solar panel thoroughly. If the issue persists after adequate charging, the battery may need replacing (if replaceable) or the unit may be nearing the end of its lifespan.

Moisten the ground slightly before insertion. If the ground is very hard, consider using a rubber mallet to gently tap the stake into place, being careful not to damage the unit. Alternatively, choose a softer location.