Ronseal Direct To Metal Paint - Gloss - Copper - 250Ml

No, Ronseal Direct to Metal Paint is specifically formulated to be applied directly to rust and metal surfaces without the need for a primer, saving you time and effort.

When applied correctly according to the instructions on the tin, the paint offers 15 years of protection.

It is suitable for use on cast iron, aluminium, steel, and wood. It can be applied to bare metal, primed metal, or previously painted surfaces.

The paint is showerproof in 30 minutes. Allow at least 4 hours between coats, but refer to the product tin for precise recoating times to ensure maximum protection.

Yes, it is designed for both interior and exterior metal surfaces, providing durable protection against weather conditions.

Yes, it can be applied directly to rust. However, it is important to remove any loose or flaking rust first for best adhesion and protection.

As this is a water-based paint, brushes and equipment can be cleaned easily with soap and water immediately after use.

Ensure the surface was properly cleaned and free of grease. Check that previous coats were adequately dry and that the correct application method was followed. Lightly abrading the surface before application can improve adhesion.

Stir the paint thoroughly before and during use. Apply thin, even coats. Avoid over-brushing or over-rolling. Ensure consistent application technique across the surface.

Ensure all loose rust was removed during preparation. Apply additional thin coats of the paint, allowing adequate drying time between each. For severe rust, specific rust-inhibiting treatments may be necessary prior to painting.

Stir the paint thoroughly. If the paint is too thick, check storage conditions; avoid extreme temperatures. This paint is water-based and should not require thinning, but if absolutely necessary and permitted by instructions, a very small amount of water can be added cautiously. Refer to the product tin for specific guidance.