Arrma Flat Head Screw - 3x8mm - Multicolor

These M3x8mm flat head screws are typically used for general assembly and mounting of components on Arrma RC vehicles where a flush or countersunk finish is desired.

Each pack contains 10 screws.

While the M3x8mm size might fit some other vehicles, these are specifically designed and manufactured to Arrma's standards. For best results and guaranteed compatibility, they should be used on Arrma vehicles as intended.

You will need a hex driver that fits an M3 size hex head.

A flat head screw has a conical underside that is designed to fit into a countersunk hole, allowing the screw head to sit flush or below the surface of the material.

You can refer to your Arrma vehicle's user manual or the exploded views available on the Arrma-RC website for detailed parts information.

This specific listing is for Multicolor. Arrma may offer the same screw size in other color families depending on the product variant.

Ensure you are using the correct size hex driver. Apply firm, consistent pressure while turning. If the head is already stripped, consider using a screw extractor tool or carefully drilling it out and replacing with a new screw.

Verify that you are using the correct M3 thread size. Check that the hole or nut is clean and free of debris. Ensure you are not cross-threading; if resistance is met, back the screw out and try again with a straight alignment.

This can indicate the screw is overtightened, cross-threaded, or that the material has been weakened. Replace with a new genuine Arrma screw and ensure proper installation technique is used, avoiding excessive force.