Actis HControl Hybrid Multifoil Insulation - 45mm

It acts as a reflective vapor control layer and provides supplementary thermal insulation, contributing to both energy efficiency and airtightness in buildings.

It should be installed on the warm side of any insulation material, typically on the interior face of roofs, walls, and ceilings, behind the final interior finish.

One roll measures 6250mm in length and 1600mm in width.

Yes, absolutely. Meticulous sealing of all joints, overlaps, and edges with Actis's approved tape is crucial for achieving airtightness and its vapor control function.

Yes, it is designed to be compatible with virtually any form of insulation, including mineral wool, foam boards, and blown insulation.

It supplements primary insulation by adding thermal resistance and creating an airtight barrier. It is not typically intended as a sole source of insulation.

Standard tools like a sharp utility knife for cutting and a stapler for fixing are generally sufficient. An approved tape is required for sealing.

Ensure all joints, overlaps, and edges are properly and completely sealed with the approved tape. Check for any punctures or gaps in the material or its sealing.

Use a sharp utility knife or a specialized cutting tool designed for insulation materials to ensure clean cuts and avoid snagging.

Verify that the multifoil is installed on the correct side (warm side) and that all potential air leakage paths, including around services and junctions, have been sealed meticulously.