Fox Edges Camo Inline Lead Drop Off Kits
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
Designed for carp anglers who frequently target snaggy or heavily weeded venues, the Fox Edges Camo Inline Lead Drop Off Kit provides a reliable mechanism to eject the lead during a fight to prevent gear loss and fish injury. This system is essential for maintaining control in difficult underwater environments, though it requires specific attention to detail during the initial rig assembly to ensure the release mechanism functions as intended.
All features
| Model Part Number | CAC1002-FX |
|---|---|
| Brand | Fox |
Extended Product Information
FAQs
How many kits are included in a pack?
Each pack contains enough components to make 5 complete drop-off systems.
Can I use this kit with leads from other manufacturers?
While it is specifically designed for Fox inline leads, it may fit other brands with similar dimensions, but performance cannot be guaranteed.
Do I need special tools to assemble this?
No special tools are required; all parts are designed for manual assembly.
Is this system safe for the fish?
Yes, by allowing the lead to eject, the risk of the lead snagging on underwater debris and causing the fish to pull the hook is greatly reduced.
Can I reuse the components after a lead drops off?
You will need to replace the lead and potentially the plug or pin if lost, but the inline insert and tail rubber can often be reused if undamaged.
Troubleshooting
Lead is dropping off prematurely during the cast
Ensure the tail rubber is pushed further onto the insert to increase tension, or check that the lead is properly seated against the insert.
Lead fails to eject when a fish is hooked
Verify that the tail rubber is not pushed on too tightly and that the line is not snagged or kinked near the lead assembly.
Pros and Cons
Pros
- Significantly increases the chances of landing fish in snaggy venues
- High-quality components with signature camo finish
- Comprehensive kit includes all necessary small parts
- Compatible with a wide range of standard inline leads
Cons
- Requires re-rigging after each lead ejection
- Not suitable for venues where lead ejection is not permitted
- Small components can be difficult to handle in cold or wet conditions
Setup, Compatibility & Care
To set up the kit, thread your main line through the inline lead, then slide the inline insert into the lead. Attach your swivel to the rig, pull it into the insert, and secure the setup using the provided plug and pin. Finally, slide the tail rubber over the end of the insert. The system is compatible with various leader materials including fluorocarbon, leadcore, and standard monofilament. To maintain the effectiveness of the kit, regularly inspect the tail rubbers for signs of fatigue or hardening, as these parts are critical to the release tension. Always store components in a dry tackle box to prevent oxidation of the pins.