FDL Patch Cable - Cat.6A - S-FTP

S-FTP stands for Shielded, Foiled Twisted Pair. It indicates that each pair of wires inside the cable is individually shielded with foil, and the entire bundle of pairs is also shielded with an overall braid.

This specific model features an LSZH jacket, which is intended for indoor use and safety compliance. It is not rated for direct outdoor exposure to UV, moisture, or extreme temperatures.

While the cable's construction can typically handle PoE, its primary design and certification are for data transmission. For dedicated PoE applications, it's recommended to use cables specifically rated and tested for PoE to ensure optimal power delivery and heat dissipation.

The standard maximum length for a permanent link (e.g., between a patch panel and a wall outlet) for Cat.6A is 100 meters (328 feet). Patch cords are typically shorter and used for connecting equipment within this distance.

Cable categories (like Cat.5e, Cat.6, Cat.6A) are usually printed directly on the cable's jacket. Different categories offer varying performance levels in terms of speed and bandwidth.

LSZH (Low Smoke Zero Halogen) jacketing is important for safety in building installations. In the event of a fire, it emits significantly less smoke and fewer toxic/corrosive gases compared to standard PVC jackets.

Ensure both ends of the cable are securely plugged into the correct ports. Test the cable with another device or port. Verify the network configuration on your devices.

Check for kinks or sharp bends in the cable. Ensure the cable is fully seated in the ports. Verify that all connected devices support Cat.6A speeds. Test with a known good cable to rule out cable damage.

Verify you are using an Ethernet port and not another type of connector. Ensure the RJ45 connector is not damaged or obstructed.