Dulux Trade Quick Dry MDF Primer And Undercoat - White

This primer is specifically designed for use on MDF (Medium Density Fiberboard) surfaces, both interior and exterior.

One coat of Dulux Trade Quick Dry MDF Primer Undercoat is generally sufficient, but a second coat may be necessary depending on the condition of the MDF and the chosen topcoat.

The primer is touch dry and recoatable in approximately 2 hours. Drying times may vary depending on environmental conditions.

Yes, this primer is compatible with a wide range of Dulux Trade topcoats. Always refer to the topcoat's instructions for specific compatibility information.

Store the primer in a cool, dry place, away from extreme temperatures and frost. Ensure the container is sealed properly.

One litre of Dulux Trade Quick Dry MDF Primer Undercoat covers up to 13 m².

Clean brushes, rollers, and other equipment with water immediately after use.

Yes, Dulux Trade Quick Dry MDF Primer Undercoat is a water-based formula, which results in a low odor compared to solvent-based primers.

Ensure the room is well-ventilated and the temperature is within the recommended range. Check for excessive humidity. Also ensure you have allowed enough drying time before applying the topcoat.

Make sure the surface was properly prepared. Ensure the surface is clean and dry before priming. Lightly sand the surface and reapply the primer if necessary.

Ensure you are applying the primer evenly and not too thinly. Apply a second coat if necessary, allowing for adequate drying time between coats.