Trend Kitchen Worktop Jig - KWJ900

A plunge router is recommended for use with the Trend Kitchen Worktop Jig. Ensure it is powerful enough for the thickness of your worktops and that it accepts the appropriate bits.

The jig is designed to accommodate worktops up to 40mm thick.

Yes, replacement pins can be purchased if needed.

Yes, the jig can be used with various worktop materials, provided you use the correct router bit for the material. Always refer to the router bit manufacturer's recommendations.

Double-check the alignment of the jig and the router bit. Make sure the worktop is square before you start cutting. Take your time and make sure you're getting the best possible result.

The engraved markings on the jig assist with pin hole identification, ensuring precise setups and accurate cuts.

Check that the router bit is sharp and properly installed. Ensure the jig is securely fastened to the worktop.

Replace worn or damaged pins. Ensure the pin holes on the worktop are clean and free of debris.

Adjust the router's cutting depth according to the worktop thickness and the jig's instructions. Make sure the router bit is long enough for the material.