Aurora LinearPac CWS Anti-Corrosive Batten - 5ft - White

The Aurora LinearPac CWS Anti-Corrosive Batten comes with a 5-year warranty.

Yes, the batten has pre-drilled cable entry points suitable for 20mm conduit, but it can also be wired directly if preferred, ensuring all entries are properly sealed.

There are integrated switches located on the batten itself. You will need to access these switches to select your desired color temperature and wattage.

Yes, it is IP66 rated, meaning it is protected against dust ingress and high-pressure water jets, making it suitable for damp and wet environments.

Yes, this batten is designed to be compatible with plug-and-play emergency lighting accessories, allowing you to add this functionality after the initial installation.

The LED has an L70 rating of 50,000 hours, indicating it will maintain at least 70% of its initial light output after 50,000 hours of use.

The 5ft model has a length of approximately 5 feet (1500mm). Specific width and depth dimensions can be found in the product's technical specifications sheet.

Verify mains power supply. Check all wiring connections to the terminal block and ensure correct polarity. Confirm the integrated switches for color temperature and wattage are set correctly.

Check for loose wire connections. Ensure the power supply is stable. If using with an external dimmer or sensor, verify compatibility and correct installation.

Ensure the color temperature and wattage switches on the batten are set to the desired positions. Re-check wiring if an optional accessory has been recently installed.

Immediately disconnect power. Inspect seals and cable entry points for damage. Do not operate until thoroughly dried and sealed. Contact support if damage is significant.