Bosch EXPERT Power Change Plus Converting Set

The primary benefit is the ability to quickly and easily change hole saws without tools, significantly improving efficiency during tasks requiring multiple hole sizes.

This set is designed for hole saws with a 60 mm cutting depth. The included adapter nuts allow you to use standard hole saws with specific thread sizes (1/2"-20UNF and 5/8"-18UNF).

Yes, as long as the hole saw has a compatible cutting depth (60 mm) and thread size (1/2"-20UNF or 5/8"-18UNF), and you are using it with a Bosch Power Change Plus Arbor.

The set can accommodate hole saws with diameters from 14 mm up to 152 mm, depending on the thread size and the adapter nut used.

No, the Bosch Power Change Plus Converting Set includes the adapter nuts and a hex shank. The Power Change Plus Arbor is a separate accessory that must be purchased if you do not already own one.

After use, remove any dust or debris with a dry cloth or brush. For tougher residue, a slightly damp cloth can be used, followed by thorough drying before storage.

The set includes an 11 mm hex shank for attachment to your drill.

Ensure both the arbor and the hole saw's shank are clean and free of debris. Verify that the correct adapter nut is being used for the hole saw's thread size. Check for any damage to the locking mechanism on either component.

Confirm that the hole saw is fully and securely locked onto the arbor. Ensure the arbor itself is properly seated in the drill chuck. Check that the drill is set to the appropriate speed for the material being cut.

Clean the threads on both the hole saw and the adapter nut. Ensure you are using the correct adapter nut for the specific hole saw thread size. Do not force the threads; if resistance is met, re-align and try again.