Plumbright Solder Ring P1 Straight Coupler Fitting - 10x10mm

A solder ring fitting has a ring of solder pre-inserted into the socket. When heated correctly, this solder melts and forms the seal.

This fitting is designed for 10mm diameter pipes.

Many solder ring fittings come with pre-fluxed solder. However, it's always good practice to ensure the pipe ends are clean and consider using additional flux if the pipes appear oxidized.

A standard propane or MAPP gas plumbing torch is typically sufficient for soldering 10mm copper fittings.

This fitting is designed for water and heating systems. Always check product specifications and local regulations for suitability with gas lines.

Proper preparation of the pipe ends, correct heating of the fitting, and allowing the solder to flow fully are crucial for a leak-proof joint.

Ensure pipes were fully inserted and the fitting was heated evenly. Reheat the joint and allow solder to flow completely. Check if pipes were properly cleaned and if sufficient heat was applied.

Increase the heat applied to the fitting. Ensure the torch flame is directed at the fitting and the pipe connection point. Verify the solder ring is correctly positioned.

The joint may not have been heated sufficiently or evenly, or the pipes were not clean. The joint will need to be cut out and re-soldered correctly.