Harris Essentials All Purpose Brush - 100mm

This brush is designed for use with masonry paints. Always check the paint manufacturer's recommendations.

Remove as much paint as possible. Clean the brush thoroughly with the appropriate solvent for your paint type (e.g., water for water-based paints). Rinse the brush until the water runs clear, reshape the bristles, and allow it to dry completely before storing.

The lifespan of the brush depends on usage and care. Proper cleaning and storage will help extend its life.

While the brush can be used on some smooth surfaces, it is specifically designed for rough, textured surfaces like brick and concrete.

Store the brush in a dry place, ideally wrapped in its original packaging or a paper sleeve to protect the bristles.

Soak the bristles in warm water (for water-based paints) or the appropriate solvent (for oil-based paints) to soften the paint, and then clean the brush thoroughly.

Ensure the brush is thoroughly cleaned before use. Remove any loose bristles by gently tapping the brush against a surface. If shedding persists, consider replacing the brush.

Ensure you are using the correct paint type for masonry surfaces. Apply paint in even strokes and avoid overloading the brush. If the surface is very porous, consider applying a primer first.

Clean the brush thoroughly to remove any dried paint. Soaking the bristles in warm water (for water-based paints) or the appropriate solvent (for oil-based paints) can help to soften them.