Cables Direct networking cable - CAT6A - 1.5m White

Cat6a offers significantly higher bandwidth (up to 600MHz compared to 100MHz for Cat5e) and supports 10 Gigabit Ethernet speeds over longer distances (up to 100 meters), whereas Cat5e is typically limited to Gigabit speeds over the same distance.

S/FTP stands for Screened (or Shielded) and Foil Twisted Pair. It indicates that each pair of wires within the cable is individually shielded with foil, and the entire bundle of pairs is also wrapped in an overall screen (braid or foil). This provides superior protection against EMI and crosstalk.

LSZH stands for Low Smoke Zero Halogen. Cables with this jacket material are designed to emit very little smoke and no toxic halogens when exposed to fire, making them safer for use in enclosed public spaces or buildings with strict safety regulations.

Yes, this Cat6a cable is fully backward compatible and will work perfectly fine with Gigabit Ethernet devices. It will simply operate at the maximum speed supported by the connected devices (e.g., 1000 Mbps).

Visually inspect the cable for any cuts, kinks, or fraying. Check the RJ45 connectors at both ends for cracks or bent pins. Ensure the locking clips are intact and functional. A damaged cable should be replaced.

UTP (Unshielded Twisted Pair) cables have no shielding, relying solely on the twisted pairs to reduce interference. S/FTP cables offer much higher protection against EMI and crosstalk due to the individual pair shielding and overall screen.

Yes, the S/FTP construction includes shielding for each twisted pair, and the RJ45 connectors are designed to maintain this shielding integrity to ensure optimal performance and protection against interference.

Verify that both ends of the cable are securely plugged into the correct ports. Ensure the connected devices support the expected speeds (e.g., 10Gbps requires compatible network cards and switches). Test with a different known-good cable to rule out a faulty cable. Check if the cable is damaged or kinked.

Inspect the RJ45 connectors for damage. Ensure the locking clip is fully engaged. Check for excessive bending or stress on the cable near the connectors. Verify that the cable is not routed too close to sources of strong electromagnetic interference.

The snagless boot is designed to protect the clip. Ensure the clip is not obstructed and is properly aligned. If the clip appears broken, the cable may need to be replaced.