Bon Tool Masonry Slicker - 1/4"
Not Available
Made from tough 1/8" thick plated steel. One end is turned up, 10” long.
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The RHINOBUILD Masonry Slicker is designed for masons and concrete professionals seeking a durable tool for smoothing and finishing mortar joints. Its key benefit is the robust steel construction that ensures longevity and consistent performance. A potential caveat is its specific 1/4" size, which may not suit all joint widths.
All features
| Model Part Number | 11-441 |
|---|---|
| Brand | RHINOBUILD |
Extended Product Information
FAQs
What material is the RHINOBUILD Masonry Slicker made from?
It is made from tough 1/8" thick plated steel.
What is the length of the slicker?
The slicker is 10 inches long.
What is the primary use of this tool?
Its primary use is for smoothing and finishing mortar joints in masonry and concrete work.
What is the specific width of the joint this slicker is designed for?
This slicker is designed for 1/4" wide joints.
Does the slicker require any assembly?
No, the slicker is ready to use out of the packaging and requires no assembly.
How should I clean the slicker after use?
Clean it with water after each use to remove mortar residue. Dry it thoroughly to prevent rust.
Can this slicker be used for applications other than mortar joints?
It is specifically designed for masonry and concrete mortar joints. Using it for other materials or tasks may not yield optimal results and could damage the tool or the material.
Troubleshooting
Slicker leaving uneven marks
Ensure the mortar is at the correct consistency (not too wet or too dry). Apply even pressure and use smooth, consistent strokes along the joint.
Difficulty cleaning off dried mortar
Soak the slicker in warm water for a few minutes before attempting to clean. A wire brush can be used cautiously for very stubborn, dried-on material.
Tool feels rough or sticky
Clean the tool thoroughly and ensure it is completely dry. Apply a light coat of oil to the steel surface for protection and smoother operation if stored for extended periods.
Pros and Cons
Pros
- Built with heavy-duty 1/8" thick plated steel for exceptional durability.
- The 10" length offers a good balance of reach and maneuverability.
- The turned-up end provides a comfortable and secure grip.
- Designed for precise finishing of 1/4" mortar joints.
Cons
- The 1/4" width is specific and may not be suitable for all joint sizes.
- Primarily suited for masonry and concrete finishing, limiting its versatility for other tasks.
- Steel construction can add weight compared to lighter materials.
Setup, Compatibility & Care Instructions
Setup: This tool requires no assembly. It is ready for immediate use out of the packaging.
Compatibility: Designed for use with standard mortar mixes and concrete. It is specifically intended for smoothing and finishing 1/4" wide joints. Not recommended for use with materials other than those found in masonry and concrete work.
Care: After each use, clean the slicker thoroughly with water to remove any residual mortar or concrete. A stiff brush can be used for stubborn residue. Dry the tool completely with a clean cloth to prevent rust and corrosion. Store in a dry place. Periodically inspect the steel for any signs of damage or excessive wear.