Sticker Remover Spray - 250ml

For most fresh residues, a few minutes is sufficient. For older or tougher adhesives, you may need to let it sit for 5-10 minutes. Watch for the adhesive to soften.

It is not recommended for use on car window tinting as it may damage the film. Always test on an inconspicuous area of the tint first if absolutely necessary, but caution is advised.

The product is designed to be safe for most painted surfaces, but it's crucial to test on a small, hidden area first. Wipe away any overspray immediately and do not let it dry on the paint.

Once the adhesive is softened, gently wipe it away with a clean cloth or paper towel. For tougher spots, a plastic scraper can be used carefully.

Please refer to the product's safety data sheet (SDS) for specific flammability information. Generally, keep away from heat and open flames.

When stored correctly in a cool, dry place with the cap tightly sealed, the sticker remover typically maintains its effectiveness for several years.

Allow the remover to sit for an extra minute or two to fully penetrate the adhesive. For very stubborn or old residue, a second application or gentle scrubbing with a non-abrasive cloth may be necessary.

This indicates the paint may be sensitive. Immediately wipe the area clean with a damp cloth and rinse with water. Discontinue use on this specific surface or test a more diluted application in an unseen area.

Ensure the nozzle is not blocked. If it is, clear it with a pin. Check that the can is held upright and the nozzle is not obstructed.