Ethernet Network Cable Reel - kenable - CAT5e

CCA (Copper-Clad Aluminium) cable has an aluminum core with a thin copper coating. It is lighter and less expensive than pure copper but offers slightly lower conductivity and can be more prone to signal degradation over longer distances.

While the cable can carry power, CCA cable is generally not recommended for high-power PoE applications due to its higher resistance compared to pure copper, which can lead to overheating and reduced efficiency.

The official standard for Cat5e Ethernet cable is 100 meters (328 feet). However, due to the CCA conductors, performance may degrade sooner, especially in noisy environments. It is best used for shorter runs or custom patch cables.

No, this cable is U/UTP (Unshielded Twisted Pair), meaning it does not have an external foil or braid shield.

Both standards are compatible for most common networking applications, as long as you use the same standard on both ends of the cable (e.g., for a straight-through patch cable). T568B is more commonly used in North America.

Keep the reel in a clean, dry environment, away from extreme temperatures and direct sunlight. Ensure the cable end is secured to prevent it from unraveling and getting tangled.

Check both ends of the cable for proper termination. Ensure the cable is not too long for the CCA conductor type. Test with a known good cable or network tester. Avoid running the cable near power lines or other sources of interference.

Re-terminate the cable ends. Ensure wires are in the correct order and fully seated in the RJ45 connector before crimping. Verify the RJ45 connector is properly crimped.

Ensure you are using the correct type of RJ45 connector designed for stranded cable. Verify that the cable jacket is properly seated inside the connector for a secure grip.