Best current price£16.87from PCHUB.UK
Shopping.co.uk recommended and popular offers
PCHUB.UK£16.87Visit shop Startech.com Brocade 57-0000075-01 Compatible Sfp+ Module - 10Gbase-Sr
Visit shop
Amazon£30.98Visit shop StarTech.com Dell EMC SFP-1G-BX80-U Compatible SFP Module - 1000BASE-BX-U - 1 Gigabit Ethernet BiDi Fiber Single Strand SFP - LC 80km (SFP1GBX80UES)
Visit shop38 offers from £16.87 - £230.06
View price history by clicking the chart icon.
The StarTech.com 57-0000075-01-ST is a high-performance fiber transceiver designed specifically for IT professionals and network administrators who need reliable 10GBASE-SR connectivity for Brocade network infrastructure. This module provides stable 10 Gbps data transfer over multi-mode fiber with a reach of up to 300 meters, ensuring seamless integration and consistent network uptime; however, users should note it is exclusively designed for use with compatible Brocade-branded hardware.
| Series | SFP+ |
|---|---|
| Model Part Number | 57-0000075-01-ST |
| Brand | StarTech.com |
This specific module is programmed and tested for compatibility with Brocade equipment; using it in switches from other manufacturers may result in compatibility errors.
This module is a 10GBASE-SR transceiver, which requires multi-mode fiber (MMF) cabling with an LC connector.
It supports data transmission up to 300 meters (984 feet).
DDM allows the network switch to read real-time operational data such as laser temperature, output power, and input power levels.
Yes, it is hot-swappable, allowing you to replace or install the module without powering down your network switch.
Ensure the module is fully seated in the SFP+ port, verify the fiber cable is properly connected, and check that the correct fiber type (multi-mode) is being used.
Use the DDM features to check signal power levels; if levels are low, inspect the fiber patch cable for bends or physical damage.
Installation of the SFP+ module is straightforward: ensure your Brocade switch is powered on and insert the module into an available SFP+ port until it clicks into place. Connect your LC-terminated multi-mode fiber optic cable to the transceiver ports. The device is hot-swappable, so no manual configuration or rebooting is typically required, though you should consult your switch's command-line interface (CLI) to verify the link state. Handle the optical interface with care; avoid touching the exposed fiber tip to prevent signal attenuation from oils or dust. When not in use, always keep the dust cap on the LC port.
