OX Pro Slotted Parallel Screwdriver - 250mm X 6.5mm

The shaft is made from a robust chrome vanadium steel bar.

The tip has a permanently magnetized end that attracts and holds small screws securely, making them easier to position and preventing drops.

No, this is a slotted parallel screwdriver and is only designed for screws with a single slot. It is not compatible with Phillips, Pozidriv, or Torx screws.

The tethering eyelet is a reinforced hole at the end of the handle used to attach a safety tether, preventing the tool from falling when working at height.

The handle is color-coded, and the size (250mm x 6.5mm) is also often marked on the tool, allowing for easy identification among other screwdrivers.

Yes, the handle is ergonomically designed with a soft grip moulded directly to the shaft for maximum strength, comfort, and control during extended use.

Wipe clean after use, store in a dry place, and periodically check the tip for wear. Avoid exposure to harsh chemicals.

Inspect the handle-moulded connection to the shaft. If significant looseness is present, the screwdriver may be compromised and should be replaced for safety.

The magnetism is inherent to the material and designed to last. If it appears weak, ensure the tip is clean of debris. Permanent magnets do not typically 'wear out' significantly.

Ensure your hands and the handle are clean and dry. The soft-grip material is designed for enhanced grip, but contamination can reduce its effectiveness.

Verify that the 6.5mm tip width is the correct match for the screw slot. Ensure the screwdriver is inserted fully into the slot before applying torque. Excessive force can also lead to cam-out.