Einhell Impact Driver - TP-CI 18/250-C Li BL

This impact driver is part of the Einhell Power X-Change (PXC) family and uses PXC batteries.

No, this is a body-only product. The battery and charger are sold separately.

The impact driver has a maximum torque of 250Nm.

There are usually multiple modes or settings. Consult the product manual for instructions on how to select the desired mode. Select the appropriate setting based on the task.

Use a soft, dry cloth to clean the tool. Do not use any liquids or abrasive cleaners.

Please refer to the product documentation or Einhell's website for warranty information.

Yes, it can be suitable for some automotive tasks, such as removing lug nuts. Always ensure the correct socket size and use appropriate safety precautions.

Check the battery, the mode settings, and the bit. Consult the troubleshooting section in this guide or the product manual for further assistance.

Check if the battery is properly inserted and charged. Ensure the battery is compatible and making good contact with the tool.

Check the battery charge level. If the battery is low, recharge it. Check the mode setting and adjust to a higher torque setting if needed. Ensure you are using the correct bit for the screw type and size.

Make sure you are using the correct bit for the screw type. Apply firm pressure to the tool while driving the screw. Adjust the speed setting to prevent over-driving the screws.

Ensure the battery is properly inserted. The light may turn off if the battery is low. The LED might be faulty, in which case contact Einhell support.