Husqvarna Automower Boundary Wire - 580662009

While other wires may conduct, the Husqvarna Automower Boundary Wire is specifically engineered to maintain the required signal integrity for your mower's electronics.

The wire can be laid directly on the surface and pinned with stakes. It does not need to be buried deep; it will be covered by grass over time.

The maximum length depends on your specific Automower model. Refer to your mower's manual for the maximum permitted loop length.

Yes, the wire must form a continuous circuit connected back to the charging station to broadcast the signal.

The wire is designed for long-term outdoor use, typically lasting several years provided it is not damaged by gardening equipment or pests.

Check the charging station status light. If it is blinking, inspect the boundary wire for any cuts, breaks, or loose connections at the docking station terminals.

Ensure the boundary wire is not placed too far from the edge of the desired cutting area. Adjust the layout to allow the mower closer access to boundaries.

Use a waterproof wire connector to splice the two ends together. Ensure the connection is fully sealed to prevent moisture from corroding the copper wire.