Best current price£54.99from eBay
Shopping.co.uk recommended and popular offers
eBay£54.99Visit shop OX Spectrum M14 102mm Dry Cut Diamond Tile Drill Bit Hole Saw Porcelain MTD102
Visit shop2 offers from £54.99 - £77.99
View price history by clicking the chart icon.
The OX Spectrum M14 Dry Cut Diamond Tile Drill (102 mm) is designed for professional tilers and serious DIY enthusiasts who require precision holes in demanding materials. It offers the key advantage of high-speed, water-free drilling, making it an efficient choice for on-site installations; however, users should note that as a dry-cut tool, it requires proper technique to manage heat buildup during extended use.
| Model Part Number | 366594 |
|---|---|
| Brand | OX |
No, this bit is designed exclusively for M14 angle grinders.
No, this is a dry-cut tool, though you should allow it to cool by air between cuts.
While it can handle most standard tile thicknesses, performance is optimized for typical wall and floor tile dimensions up to 20mm.
Yes, it is highly effective on marble and granite.
The bit is effectively worn out when the diamond segments are no longer visible or the cutting performance remains poor even after dressing.
Use a guide or start the hole with the bit at a 45-degree angle to create a starting notch before moving to 90 degrees.
The diamond segments may be glazed over; use a diamond dressing stone to sharpen the segments.
Ensure the M14 fitting is fully tightened to the angle grinder spindle and check that the grinder speed is set appropriately.
To set up, thread the drill bit onto the M14 spindle of your angle grinder and tighten firmly by hand or with the provided wrench. Always ensure the grinder is unplugged while changing bits.
Compatibility: This bit is specifically designed for use with angle grinders. It is not compatible with standard cordless or corded drill-drivers as they lack the necessary RPMs and mounting interface.
Care: To maximize the lifespan of your bit, allow the tool to cool down after every 30-60 seconds of continuous use. If you notice the cutting speed decreasing, run the drill through an abrasive stone to "dress" the diamond segments and expose new cutting edges.
