OM SYSTEM Underwater Case - PT-059

The PT-059 housing is rated for use down to a depth of 45 meters (approximately 147 feet).

Yes, the housing allows the use of the camera's built-in flash, but it is also designed to support external underwater flash units for more advanced lighting control.

Gently wipe the O-ring with a clean, lint-free cloth. Ensure there is no sand, salt, or other debris. A small amount of silicone grease may be applied to keep it pliable and ensure a good seal, but avoid over-application.

Yes, the housing provides access to all camera functions, including the zoom control, allowing you to adjust your field of view as needed.

The housing leverages the camera's dedicated underwater modes: Underwater Snapshot, Underwater Wide, Underwater Macro, Underwater Microscope, and Underwater HDR, optimizing settings for different underwater conditions.

No, the PT-059 housing is exclusively designed and tested for the OM SYSTEM Tough TG-6 and TG-7 cameras.

You can connect external underwater strobes using optional fiber optic or electrical sync cables through the designated ports on the housing, enabling more sophisticated lighting setups.

Ensure the O-ring is clean, free of debris, and properly seated. Re-apply silicone grease if necessary. Never force the housing shut if it doesn't seal easily. Always perform a test dive in shallow water after sealing.

Check for any debris obstructing the button or dial mechanisms. Ensure the camera is correctly seated within the housing. Rinse the housing in fresh water after saltwater use and allow it to dry completely.

Condensation can occur due to temperature changes. Use anti-fog inserts (sold separately) inside the housing before sealing. Ensure the camera and housing are at a similar temperature before sealing.

Verify that the external flash units are properly connected via the appropriate cables. Ensure the external flashes are powered on and set to trigger. Check camera settings to ensure external flash control is enabled.