Block Plane - Spear & Jackson - CBP65

This block plane is primarily designed for efficient end-grain work, chamfering edges, and detailed fitting tasks where single-handed operation is beneficial.

The cutting depth is adjusted using the brass screw located at the rear of the plane. Turn the screw clockwise to increase depth and counter-clockwise to decrease it.

The adjustable mouth controls the size of the opening through which shavings exit. A narrower mouth helps prevent tear-out on difficult grain and allows for finer shavings, while a wider mouth allows for faster material removal.

While it can plane surfaces, its compact size and design make it best suited for smaller tasks, end grain, and chamfers, rather than large, flat surfaces.

After use, wipe the plane clean and dry. Apply a light coat of paste wax or tool oil to the cast iron body and cutter, and store in a dry place.

The block plane features a 35mm wide low angle cutter.

Yes, the design is generally ambidextrous, allowing for comfortable single-handed use by both right and left-handed individuals.

Check if the cutter is sharp. Ensure the cutter is properly seated against the cap iron. Adjust the mouth opening to be narrower. Verify that the base and cap iron are clean and free of debris.

Clean the depth adjustment screw threads. Ensure the screw is moving freely. Check that the cutter is held firmly by the cap iron.

Ensure the cutter is extremely sharp. Adjust the mouth to be as narrow as possible for the task. Try planing with the grain direction. For difficult grain, a very fine shaving setting is crucial.

Ensure the adjustment mechanism is clean and free of obstructions. Apply a small amount of lubricant if necessary, but avoid over-lubrication that could attract dust.