Bostitch Finish Staples - 15mm - Pack Of 5000

The crown width for these Bostitch finish staples is 5.6mm.

Yes, the galvanised finish provides corrosion resistance, making them suitable for applications exposed to moisture. However, prolonged and extreme exposure may eventually affect the coating.

No, these staples are only compatible with specific Bostitch pneumatic finish stapler models listed in the compatibility section. Always verify your tool's model.

Each pack contains 5000 staples.

These staples feature a CP (Chisel Point) for efficient penetration.

While generally not an issue, it's advisable to test any specific adhesives on a scrap piece if you are concerned about interaction, especially with sensitive glues or finishes.

Ensure the staple strip is correctly seated in the magazine and not bent. Check for any debris obstructing the feed mechanism. Verify you are using the correct staple size and collation for your tool.

Check the air pressure setting on your pneumatic stapler. Ensure the tool is appropriate for the material being fastened. Inspect the driver blade for wear or damage.

Carefully unload the tool and remove the jammed staples. Refer to your stapler's manual for specific jam clearing procedures. Ensure staples are loaded straight and correctly aligned.

Store unused staples in a dry, sealed container. If minor surface oxidation is present on new staples, it typically does not affect performance but prolonged exposure to moisture should be avoided.