Dremel 565 Multipurpose Cutting Attachment - Dremel

The Dremel 565 Multipurpose Cutting Kit is suitable for cutting fiberglass, laminate, and plastic.

It is compatible with Dremel models 400, 300, 398, 395, 200, 100, 800, and 780.

The kit allows for easy depth adjustment up to 19 mm (approximately 0.75 inches).

The kit may come with additional bits such as the Dremel 560 Drywall Cutting Bits and Dremel 561 Multipurpose Cutting Bit, but this can vary. It is designed to work with appropriate Dremel cutting bits.

The 565 is designed for controlled, freehand cuts of any shape. While it offers more control than freehand cutting with just the rotary tool, achieving perfectly straight cuts may require additional guidance or practice.

You screw the attachment onto the threaded nose piece of your compatible Dremel rotary tool, then insert and tighten your chosen cutting bit into the collet.

Verify that your Dremel rotary tool model is listed in the compatibility list. Ensure the attachment is correctly aligned with the tool's threaded nose piece.

Ensure the cutting bit is sharp and appropriate for the material. Adjust the cutting speed on your rotary tool. Practice freehand control with lighter pressure. Check that the depth adjustment is set correctly.

Ensure the attachment is securely tightened to the rotary tool's nose piece. Check that the cutting bit is properly secured in the collet. Verify that the rotary tool itself is in good working order.

Ensure the depth adjustment mechanism is clean and moving freely. Re-adjust the depth setting carefully before each new cut.