Orange Glitter Translucent Glossy Acrylic Sheet - 3mm - 3pcs - xTool

Yes, it is essential to peel off the protective film from both sides of the sheet before laser processing to ensure a clean finish and safe operation.

While casted acrylic is durable, prolonged exposure to extreme UV rays may eventually affect the clarity of the material over several years.

Yes, but ensure your diode laser has sufficient power for 3mm material and perform a test cut to determine optimal passes and speed.

Use a microfiber cloth dampened with water and a tiny amount of mild dish soap to wipe away dust and fingerprints.

Due to the manufacturing process, you should expect a tolerance of up to 1/2 inch in length/width and 1/12 inch in thickness.

Check that the focal length is set correctly for 3mm thickness and verify that the laser power settings match the provided QR code parameters.

Ensure that your air assist is running at the correct pressure and try increasing the cutting speed while slightly adjusting the power percentage.

Ensure the sheet is held flat against the laser bed using magnets or pins, and store remaining sheets horizontally in a climate-controlled environment.