Simply 6T Bottle Jack - BJ6T

The Simply 6T Bottle Jack has a lifting capacity of 6 tons (approximately 12,000 pounds).

The lifting height range is from 274mm (minimum height) to 415mm (maximum height).

Always place the jack on a firm, level surface directly under the load's lifting point. Close the release valve completely before pumping. Never exceed the jack's weight capacity.

Use a high-quality hydraulic jack oil. Refer to the product manual for specific recommendations if available.

Yes, it is suitable for lifting vehicles, provided the vehicle's weight is within the 6-ton capacity and it is used on a stable, level surface.

The jack includes built-in overload protection to prevent exceeding its rated capacity and a stable base design for improved stability.

Store the jack in a clean, dry location. It is recommended to fully retract the ram to protect it from dust and corrosion.

Ensure the release valve is fully closed (turned clockwise). Check the hydraulic fluid level and top up if necessary. Verify the object's weight does not exceed the jack's capacity.

Check for air in the hydraulic system. Slowly open the release valve fully, then close it completely to purge air. Ensure the jack is on a level surface. Inspect for any hydraulic fluid leaks.

Check the hydraulic fluid level. If low, add the correct type of hydraulic oil. Ensure the release valve is fully closed. Inspect the pump mechanism for any obstructions.

Discontinue use immediately. Contact customer support or a qualified service center for repair or seal replacement.