Simpson Strong-Tie Restraint Strap - Silver

Its primary purpose is to provide vertical and horizontal restraint, securing timber floors and roof systems to masonry walls to prevent movement and ensure structural stability.

Yes, it conforms to BS EN 5268 Part 3, a key standard for timber structures in the UK.

The strap has a width of 28mm and a thickness of 4mm, with a length of 1000mm.

It is made from heavy-duty galvanised edge-coated steel.

It is designed for connecting to masonry walls and is compatible with standard timber floor and roof systems.

Appropriate structural screws for timber and masonry anchors for the wall are recommended. The specific type and size of fixings should be determined based on the load requirements and substrate material, consulting structural guidelines.

The strap is pre-galvanised and edge-coated for protection. Avoid damaging the coating during installation. If damaged, touch up with a suitable galvanising repair paint.

Verify that the correct fixings are used and properly installed in both the timber and masonry. Ensure the strap is tensioned correctly and aligned to provide both vertical and horizontal restraint as designed. Check for any damage or deformation of the strap.

Ensure the original protective coating was not significantly damaged during installation. If minor scratches occurred, touch up with a compatible galvanising paint. For extensive corrosion, the strap may need replacement.

Ensure the timber and masonry elements are correctly positioned. For minor adjustments, consider pre-drilling pilot holes in the timber or using appropriate masonry drilling techniques for fixings. Ensure the correct strap length is used for the application.