BlueSpot External Chamfer Deburring Remove Tool - 3mm - 19mm

The shank size is 1/4in Hex.

The chamfer angle is approximately 50°.

You can use this tool on stainless steel, hardened steel, mild steel, copper, brass, fibreglass, and hard plastic.

Yes, this tool is designed for use with electric drills.

The tool can handle threads and studs ranging from 3mm to 19mm.

Clean the tool after each use to remove debris. Store it in a dry place. Avoid dropping or applying excessive force.

Check the drill speed and applied pressure. Make sure you are using the correct speed and pressure for the material. Also, ensure the tool is properly seated on the damaged thread/stud.

Check for any damage to the Tungsten Carbide blades. Replace if necessary. Ensure you are not applying excessive force or using the tool on inappropriate materials.